Perlick PEF: the evaporator probe needs attention
PEF is the evaporator probe code on G5 units.
Mon–Sat, 8am–8pm
- Temperature sensors
- Freezer thermostat and temperature control repair
- Source: Perlick
Book a visit
Three short steps, about a minute.
or call (844) 456-4651
Loading appointment form…
The appointment form couldn’t load. Please try again.
What PEF
actually means.
PEF is the evaporator probe code on G5 units. The control reads the evaporator temperature to manage defrost; without it, frost can build on the coil. Perlick’s step is the same as for the zone probe: acknowledge it and book service if it repeats within a week.
Perlick freezer display
What to do when PEF shows on the freezerKind of codeTemperature sensors
The control lost its reading of how cold the cabinet, the coil or the air around the freezer is, because a thermistor reports nonsense or its wire came loose. Without that number the control either runs the compressor without stopping or lets the cabinet drift warm. A sensor packed in frost and a connector loosened by a move are checked before the sensor itself is replaced.
Usually leads toFreezer thermostat and temperature control repair
Repairing the dial thermostat or the sensor and control that decide when a freezer cools, so it stops running without end or quitting too early.
Shows up asFreezer Error Code
A freezer error code appears on the display: letters and digits, a flashing temperature, or a warning symbol, sometimes with an alarm and sometimes with the freezer still running.
MakePerlick
Perlick freezers repaired in place, whether the trouble is soft food, a stubborn alarm or frost on the walls.
SourcePerlick G5 User Installation & Operation Manual, Form Z3023 (linked from the G5 Luxe 24-inch freezer drawers page)
Perlick G5 undercounter models with the touch display, including the G5 Luxe 24-inch freezer drawers (URS24E61). The code appears in Alarm History, which keeps the last ten alarms with date and time.
Before you book,
in this order.
Each step comes from Perlick's own guidance for PEF on its freezers. Follow it to the end: the last card says whether this is a visit.
Acknowledge the code on the display.
Watch for frost building up at the back of the cabinet or a slow rise in temperature.
Book a visit if PEF comes back within a week.
Still there?
It usually turns into freezer thermostat and temperature control repair. Book with the code and the model number.
What not to do
PEF is not the cabinet probe, which is P1F. It also does not report a low coil temperature by itself; that is TEL or TEY.
What you may
notice with it.
The freezer problems PEF tends to arrive with. Answer these at the freezer before anyone is booked.
All problems
Where PEF usually leads
Freezer thermostat and temperature control repair.
Perlick
freezers.
Perlick freezers repaired in place, whether the trouble is soft food, a stubborn alarm or frost on the walls.
Perlick freezer repair
In Perlick's own words
PEF Evaporator Probe Fault
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Perlick G5 undercounter models with the touch display, including the G5 Luxe 24-inch freezer drawers (URS24E61). The code appears in Alarm History, which keeps the last ten alarms with date and time.
Perlick PEF freezer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about PEF.
Can I clear PEF myself?
Where is the evaporator probe on a Perlick freezer?
Why would PEF cause frost in Perlick drawers?
Can I run a manual defrost with PEF showing?
Back to your everyday
Still showing PEF?
Book with the code or the alarm pattern written exactly as the freezer shows it, the full model number, and whether the food is still frozen hard — when there is a code, that is where the diagnosis starts.